Getting Start - Hama WFC-970 Bedienungsanleitung

Remote Thermo-Hygrometer
1. Today Weather Information including Wind Speed, Wind
Direction and the probability of Rain/Snow/Hail, Day &
Night Temperature, Day & Night Weather Status.
2. Tomorrow, One-Day-After and Two-Day-After Weather
Information including Day & Night Temperature, Day &
Night Weather Status.
3. In/Outdoor Temperature/Humidity
4. Information Window.
There are total 7 buttons on the Main unit, namely:
SET
• selected city  DATE  Weekday alarm "OFF
W-ALM"  single alarm "OFF S-ALM"  Pre-alarm
"OFF P-ALM"
• Press and HOLD [SET] for 3 seconds to select your (1) coun-
try, (2) time zone, (3) language, (4) exit to city display mode
DAY/NIGHT
• Critical weather information  day/night weather status
change
• Read critical weather information one by one
• increasing the value during setting
• turn ON the alarm
• Press and hold for 3 seconds to enforce a radio controlled
clock DCF signal search
• switch to next day´s weather information
1
2
3
4
Main Unit
• decreasing the value during setting
• Chose one of the pre-selected cities
• Turn OFF the alarm
• Press and hold or 3 seconds to enforce a wireless RF signal
search from remote sensor
MEM
• display the maximum and minimum measured temperature
and humidity readings in record
• Press and hold for 3 second to clear all the max. and min.
record
TEST
• Find the place for the device which has a good reception
• add the city into the list of your desired cities
OR
Remove the city out of the list of desired Cities
• edit your home town
CHANNEL
• switch to rear outdoor temperature and humidity readings
of channels 1, 2 and 3
• press and hold for 3 seconds to enter into the auto-circula-
tion display mode

GETTING START

• Insert 2pcs AAA batteries for remote sensor, and then
insert 2pcs AA batteries for the main unit.
• The main unit will automatically scan for the radio-control-
led clock signal and the Meteotime Weather signal
• The time and date will appear in a few minutes. Since there
is a large amount of Weather information for all regions and
days, the unit needs about 24 hours from the time of the
initial setup to complete the reception of all data.
• After the time and the date signal is being received
successfully, the display shows SELECT COUNTRY and then
"FRANKFURT" as default city in the information window. To
change the country and the city please see the information
below.
11