Getting Started; Installation - Hama EWS Intro Bedienungsanleitung

Warning – Batteries
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that match
the specified type.
• Do not mix old and new batteries or batteries of a
different type or make.
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking or
exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries
and keep them away from uncoated metal objects.
• Outdoor temperatures below 0°C/32°F can reduce
the battery performance of the sensor and lead to
inefficiency in wireless transmission.
• Declining battery capacity can result in reception and
transmission difficulties, and it may become difficult to
read the display.

4. Getting Started

4.1 Insert batteries
Note
Before use, ensure you insert the batteries in the measuring
station first and then in the base station.
Measuring station
• Open the battery compartment (30) and remove the
contact breaker.
• Then close the battery compartment cover.
• The status LED lights up.
Base station
• Open the battery compartment (26) and remove the
contact breaker.
• Then close the battery compartment cover.
4.2 Replacing the batteries
Note – Replacing the batteries
• Note that the stations have to be resynchronised each
time after you change the batteries in the measuring
or base station.
• To do this, remove the batteries from the other station
and then reinsert them, or change them as required.
Measuring station
• If the symbol (next to the outdoor temperature (13)) is
displayed, replace the two AA batteries of the measuring
station with two new ones.
• Open the battery compartment (30), remove and properly
dispose of the dead batteries and insert
• two new AA batteries with the correct polarity. Then close
the battery compartment cover.
Base station
• If the symbol (next to the indoor temperature (17)) is
displayed, replace the two AA batteries in the base device
with new ones.
• Open the battery compartment (26), remove and properly
dispose of the dead batteries and insert two new AA
batteries with the correct polarity. Then close the battery
compartment cover.

5. Installation

Note – Installation
• We recommend initially placing the base and measuring
stations in the intended locations without installing them
and making all the settings described in
6. Operation – to do.
• Only install the stations once the appropriate settings
have been made and a stable wireless connection is
established.
3