Hama WFC-970 Bedienungsanleitung Seite 17

Channel Auto-Scan Display:
• Press to enable an automatic scan of all channels, press
and [CHANNEL], until the
measurements from each remote channel will be
alternately displayed with a 5 seconds viewing.
NOTE: the channel auto-scan feature can be active only if
there are more than one remote sensors operating and are set
to different channels.
MAXIMUM AND MINIMUM TEMPERATURES
• The maximum and minimum record indoor and outdoor
temperatures and humidity will be automatically stored in
the memory of the main unit. To display them, press [MEM]
button and the respective indicators, [MAX] or [MIN] will
be displayed.
• To clear the memory, hold [MEM]button for 3 seconds.
The maximum and minimum temperature records will be
erased.
ALARM FEATURE
Weekday Alarm:
• This is a repeat alarm that will activate daily from Monday
to Friday at a set time.
Single Alarm:
• This is a single alarm that will activate once at a set time
HOW TO SET ALARM
• Press [SET] to toggle between weekday, single alarm time
or pre-alarm. If the alarm is disarmed, the time will be
displayed as "OFF W-ALM"
• Hold [SET] for 3 seconds, the hour digits will blink
• Enter the hour by using UP [
• Press [SET]) to confirm, the minute digits will blink
• Enter the hour by using UP [
• Press [SET] to exit and the respective alarm icons
will be activated.
HOW TO STOP ALARM
• When alarm is on, the respective alarm icons
will be flashing. Press UP [
stop the alarm immediately.
• To turn off the alarm press UP [
change the alarm time display as "OFF W-ALM"
• If no button is pressed, the alarm will be sounded for 2
minutes and then deactivated automatically.
icon is displayed. The
] or DOWN [ ] button
] or DOWN [ ] button
and
and
] or DOWN [ ] button to
] or DOWN [ ] button to
SETTING THE ICE WARNING ALARM (PRE-ALM)
• If weekday (W) or Single day (S) alarm is set, the ice
warning alarm (Pre-ALM) can be programmed.
• Press and hold [SET] button for 3 seconds once to enter
into the ice warning alarm setting mode on "PRE-ALM"
display mode
• The number 15 will flash, meaning that if selected, the
alarm will sound 15 minutes earlier than the weekday or
single alarm.
• select the desired ice warning alarm interval in 15 minutes
increments between 15 and 90 minutes, using UP [
DOWN [ ] buttons
• Press [SET] button to confirm and exit from the alarm
setting mode.
SPECIFICATION ON IN/OUTDOOR TEMPERATURE AND
HUMIDITY MEASUREMENT
Temperature Resolution:
Temperature operating range (main unit)
Temperature operating range (sensor unit) -40 degree °C to +70
Temperature accuracy
Humidity Display Range
Humidity resolution
Humidity accuracy
RF Transmission frequency
RF transmission range
Main unit is powered by AA batteries x 2pcs.
Outdoor thermo-hygrometer is powered by AAA batteries x 2pcs.
12. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [123131] is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address: www.hama.com -> 123131 -> Downloads.
Frequency band(s)
Maximum radio-frequency power
transmitted
0.1 degree °C
-5 degree °C to +50
degree °C
degree °C
+/- 1 degree °C
r.H. 1% to 99%
+/- 5% (within 25% - 80% at 25°C)
433MHz
maximum 30 meters (open area)
433MHz
0,021mW
] or
1%
17