Electrical Connection; Start-Up; Setting Shutter; Characteristic Curves - Maico AE 10 Montage- Und Betriebsanleitung

UK │ 12. Electrical connection

12. Electrical connection

1. Switch off mains fuse and prevent from
being started up again. Attach a warning
sign in clearly visible place.
2. Remove cover [8].
3. Perform wiring at the connection terminal
[5] as shown in the wiring diagram.
4. Fit cover [8].

13. Start-up

1. Check that the technical data has been
adhered to  rating plate.
2. Run function test.

14. Setting shutter

With setting screws [2] and [9], you determine
the opening and shutter angle of the lamellae.
Basic ventilation in switching status "Off"
with lamellae that are always slightly open.
Maximum ventilation in switching status "On".
14.1 Opening angle (Basic
ventilation/minimum ventilation)
The opening angle can be read on
the scale [10].
NOTICE
Do not screw the setting screw [9] too
far into the housing, otherwise it will fall
into the housing.
14
1. Set minimum lamellae opening angle with
setting screw [9]. For setting values 
following characteristic curves, value "X".
14.2 Shutter angle (maximum
ventilation)
The shutter angle can be read on the
scale [10].
1. Set the maximum lamellae shutter angle
with setting screw [2]. For setting values 
following characteristic curves, value "X".

14.3 Characteristic curves

Characteristic curves for AE 10
X = opening and shutter angles setting
Characteristic curves for AE 16
X = opening and shutter angles setting