ausdom ANC7 Anleitung Seite 4

each other.
5. Press the power button for 5-6 seconds until the LED
flashes blue and red alternately to enter pairing mode.
You will hear a prompt tone.
6. As soon as the system detects the new device and
select "AUSDOM ANC7 ".
7. If your computer ask you to enter the PIN code, please
enter 0000(4 zero). Once successfully paired, the LED
turns to flash blue.
5-2 Pairing the headsets with a phone
1. Make sure the headset is off.
2. Do not place both devices more than one meter away
from each other.
3. Press the power button for 5-6 seconds until the LED
flashes blue and red alternately, which means pairing
mode. You will hear a prompt tone.
4. Start Bluetooth function on your phone and search for
new devices.
5. Select the "AUSDOM ANC7" to pair. Once success-
fully paired, the LED turns to flash blue. You will hear a
prompt tone.
5-3 Connecting to paired devices
ANC7 will pair with the last paired device automatically
when turned on. But for some computers or laptops you
will need to manually pair every time.
Note: There will be a prompt tone when first pairing.
6.Noise Canceling
AUSDOM ANC7 contains a noise canceling circuit, It
actually senses outside noise with built-in microphones
and sends an equal-but-opposite canceling signal to the
headphone. Noise mainly in an airplane, buses or trains
is effectively reduced. Noise in office environment (PC,
copier, air ventilation, etc.) is effectively reduced.
1).The noise canceling effect may not be pronounced in
a very quiet environment, or some noise may be heard.
2).The noise canceling effect may vary depending on
EN-3