Technical Data; General; Resistance To Penetration By Infectious Agents; Resistance Of The Suit Material - Dräger CPS 7900 Gebrauchsanweisung

Technical data

8 Technical data
8.1

General

Sizes in cm:
Height
Suit
measure-
size
S 150-165 80-118
M 160-175 80-118
L 170-185 80-118
XL 180-200 104-124
XXL 195-210 104-124
Sizes in inch:
Height
Suit
measure-
size
S 59-65
M 63-69
L 67-73
XL 71-79
XXL 77-83
Weight:
Without boots approx. 5.1 kg
With boots approx. 6.6 kg
Material:
Chemical protective D-mex
suit
Visor Special polyvinyl chloride
Gloves Butyl or
Viton/Butyl or
Silvershield: EVOH/PE or
K-mex Gigant: Kevlar or
Tricotril: Nitrile/Kevlar
Safety boots Nitrile-P
black, FPA-CR safety boots
Socks D-mex
Colors:
Outside/inside blue/gray
orange/gray
olive/gray
beige/gray
Temperatures:
During operation -40 °C to +70 °C
lower temperatures up to -80 °C are
possible with short-term exposure and
are tested for D-mex material (tested by
Dräger, however not in the scope of the
EC type-approval test).
During storage -30 °C to +60 °C
36
Chest Waist
measure- persons
ment ment
72-106 <80 kg
72-106 >80 kg
72-106 <100 kg
95-110 <120 kg
95-110 <140 kg
Chest Waist
measure- persons
ment ment
31-45 28-41 <175 lb
31-45 28-41 >175 lb
31-45 28-41 <220 lb
41-48 37-43 <265 lb
41-48 37-43 <310 lb
Possible glove combinations:
Combination 1
Combination 2
For
with
Combination 3
8.2 Resistance to penetration by infectious
agents
For
Test
with Resistance to
contaminated liquids under
hydrostatic pressure
Resistance to infectious
agents in the case of
mechanical contact with
substances containing
contaminated liquids
Resistance to biologically
contaminated dusts
Resistance to biologically
contaminated aerosols
1 according to EN 14 126:2004
8.3

Resistance of the suit material

Test
Abrasion resistance
Flex cracking resistance
Flex cracking resistance at
-30 °C
Tear propagation
resistance
Bursting resistance
Piercing resistance
Resistance to ignition
Seam strength
Tensile strength
1 according to EN 943-1:2002
2 according to NFPA 1991:2005: Class 5
for EN 943-1/2:
on the inside chemical resistant Viton/
Butyl glove, on the outside optional cut
and puncture-resistant Tricotril glove
for EN 943-1/2:
on the inside chemical resistant
Silvershield glove, on the outside cut
and puncture-resistant Tricotril glove
for NFPA 1991:
on the inside chemical resistant
Silvershield glove, on top puncture-
resistant Butyl glove, on the outside cut-
resistant K-mex Gigant glove
Result
Hydrostatic
pressure:
20 kPa
Breakthrough
time: >75 min.
Penetration:
<1 log cfu
Penetration:
log r endless
Result
>2000 cycles
>100000 cycles
>4000 cycles
>40 N
>850 kPa
>50 N
Self-
extinguishing
>500 N
>1000 N
Dräger CPS 7900
1
Class
6
6
3
3
1
Class
6
6
2
6
3
6
3
3
6
6