Berner BCLL TOP Bedienungsanleitung Seite 70

EN G LI S H
THE LASER BEAMS FLASH (FIG. 2)
The BCLL TOP is designed to self-level up to an average of 4° in all
directions when positioned as shown in figure 2. If the laser is tilted
so much that the internal mechanism cannot level itself, it will flash
the laser beams – the tilt range has been exceeded. THE FLASHING
BEAMS CREATED BY THE LASER ARE NOT LEVEL OR PLUMB AND
SHOULD NOT BE USED FOR DETERMINING OR MARKING LEVEL
OR PLUMB. Try repositioning the laser on a more level surface.
THE LASER BEAMS WILL NOT STOP MOVING
The BCLL TOP is a precision instrument. Therefore, if the laser is not
positioned on a stable (and motionless) surface, the laser will continue
to try to find level. If the beam will not stop moving, try placing the laser
on a more stable surface. Also, try to make sure that the surface is
relatively flat, so that the laser is stable.
Laser Accessories (Optional)
DIGITAL LASER DETECTOR: BCLLD (DETECTOR) (FIG. 9)
The Berner Digital Laser Detector helps in locating a laser beam
emitted by the laser in bright light conditions or over long distances.
The detector can be used in both indoor and outdoor situations where
it is difficult to see the laser beam.
The detector is designed exclusively for use with the BCLL BASIC and
the BCLL TOP line lasers. It is not for use with rotating lasers.
The detector gives both visual signals through the LCD display window
(m) and audio signals through the speaker (n) to indicate the location of
the laser beam.
The Berner Digital Laser Detector can be used with or without the
detector clamp. When used with the clamp, the detector can be
positioned on a grade rod, leveling pole, stud or post.
Batteries (fig. 9)
The digital laser detector is powered by a 9-volt battery. To install the
battery provided, lift up on the battery compartment cover (o). Place
the 9-volt battery in the compartment, aligning the battery as shown
on the embossed icon.
68