Using The Laser - Berner BCLL TOP Bedienungsanleitung

EN G LI S H
OPERATION
To Turn the Laser On and Off (fi g. 1)
With the laser off, place it on a flat surface. This model has three
ON/OFF buttons, one for a horizontal laser line (c), one for a vertical
laser line (d) and one for a side vertical laser line (e). Each laser line is
powered on by pressing its ON/OFF button. The laser lines can be
powered one at a time or at the same time. Pressing the ON/OFF
buttons again turns the laser lines off.

Using the Laser

The beams are level or plumb as long as the calibration has been
checked (see Field Calibration Check) and the laser beam is not
flashing (see Out of Tilt Range Indicator).
OUT OF TILT RANGE INDICATOR (FIG. 2)
The BCLL TOP laser is designed to self-level. If the laser has been tilted
so much that it cannot level itself (average > 4° tilt), it will flash the laser
beam. The flashing beam indicates the tilt range has been exceeded
and IS NOT LEVEL (OR PLUMB) AND SHOULD NOT BE USED FOR
DETERMINING OR MARKING LEVEL (OR PLUMB). Try repositioning
the laser on a more level surface.
SLOPING THE LASER
If the BCLL TOP laser is tilted beyond 15° out of level, its laser beams
will stay on longer between flashes to make it easier to do angled work.
USING THE PIVOT BRACKET (FIG. 1)
The BCLL TOP laser has a magnetic pivot bracket (f) permanently
attached to the unit. This bracket allows the unit to be mounted to any
upright surface made of steel or iron. Common examples of suitable
surfaces include steel framing studs, steel door frames and structural
steel beams. The bracket also has a keyhole slot (g) allowing the unit to
be hung from a nail or screw on any kind of surface.
WARNING: Position the laser and/or wall mount on a
stable surface. Serious personal injury or damage to the
laser may result if the laser falls.
62