Technical Data - Cleanmaxx 01774 Gebrauchsanleitung

Cleaning the Insert and Filter
1. Remove the insert (14) with fi lter (15) from the collecting container (4) (see the sec-
tion above).
2. In the case of dry dirt, tap out the insert and the fi lter over the dustbin. In the case of
wet dirt, rinse out the collecting container under running water and allow it to dry in
the air. Remove the silicone plug (16) from the insert so that it can dry better.
PLEASE NOTE: The fi lter must not be wet-cleaned. Allow the fi lter to dry and then
tap it out.
3. Allow all parts to dry completely in the air before the device is reassembled. Under
no circumstances should it be dried with a hair dryer!
Cleaning the Main Unit and Accessories
• Wipe down the main unit (8), the nozzles and the spray bottle (14) with wiping attach-
ment (a) with a damp, soft cloth if necessary. Then dry with a soft cloth.
• Clean the spray bottle and the wiping attachment under running water if necessary.
• Wash the wiping cloth (d) in accordance with the washing instructions after each use.
• Regularly remove hair and fl uff from the nozzles and brushes.
• Check the adapter and its mains cable for damage on a regular basis.
Storage
• For practical storage, the main unit can be hung in the wall bracket.
• Store the device and all accessories in a cool, dry place which is protected from direct
sunlight and is out of the reach of children and animals.

Technical Data

Article number:
ID of instructions:
Device
Model number:
Power supply:
Power:
Battery charge time:
Battery operating time:
Fill level of collecting con-
tainer:
Adapter
Model number:
Input:
Output:
Protection class:
25
01774
Z 01774 M DS V2 1018
PC-P002W
7.2 V DC (6x 1.2V Ni-MH batteries, AA type), 1300 mAh
50 W
approx. 8 – 10 hours (the fi rst charge lasts for 12 – 15
hours)
30 minutes
max. 200 ml
LK-D090020
230 – 240 V ~ 50 Hz
9 V DC, 200 mA
II
EN