Lincoln Electric POWER MIG 180C CE Bedienungsanleitung Seite 9

a. Top and Bottom Drive Roll - Drives the wire
through the drive system. The drive roll has a
groove to match the specific wire type and
diam-eter. Refer to Table B.1 for available
drive rolls.
b. Inner & Outer Wire Guide - Guides the wire
between the Top and Bottom Drive Roll and
through the wire drive. The inner guide has a
groove to match a particular wire diameter.
Refer to Table B.1 for available wire guides.
c. Drive Roll Tension Thumbscrew - Turning
clockwise increases the force on the drive rolls
and turning counterclockwise decreases the
force.
Table B.1: Drive Roll and Wire Guides
Wire Diameter &
Type
0.6mm MIG wire
0.6mm/0.8mm Smooth Drive Roll
0.8mm MIG wire
0.9mm MIG wire 0.9mm Smooth Drive Roll
0.8mm flux-cored
0.8mm/1.1mm Knurled Drive Roll
0.9mm flux-cored
1.1mm flux-cored 0.8mm/1.1mm Knurled Drive Roll
SETTING UP AND MAKING A FLUX-
CORED WELD
Items Needed for Flux Cored Welding
1. 0.9mm Contact Tip
2. 0.6mm-0.9mm wire guide
3. Knurled Drive Roll
4. 0.9mm NR-211MP Flux-Cored Wire
5. Black Flux Cored gun nozzle
6. Welding Gun
7. Work Cable & Clamp
Connect Leads and Cables on the
Machine
Drive Roll Drive Roll Part
12. CIRCUIT BREAKER: If the rated input current of
the machine is exceeded this circuit breaker will trip.
Press to reset.
13. GAS INLET: Shielding gas connects to this inlet.
Inner Wire Guide
Number
KP2529-1
KP2529-2 0.6mm-0.9mm Steel Wire Guide
KP2529-3
KP2529-3 1.1mm Steel Wire Guide
1. Open the case side door.
2. Slide the connector end of the gun and cable
through the hole in the machine front and into the
gun connector bushing on the wire drive.
3. Make sure the gun connector end is seated fully into
the wire drive and tighten the thumbscrew to secure
the gun connector.
4. Plug the gun trigger lead connector into the 4 pin
gun trigger receptacle on the machine front.
5. Wire Drive Polarity. Flux cored welding requires
negative (-) polarity. Connect the short power cable
from the wire drive to the negative (-) output
terminal and tighten the thumbscrew.
6. Work Lead Connection. Slide the lugged end of the
work cable through the hole in the machine front
and place on the positive (+) output terminal and
tighten thumbscrew.
A-4
Inner Wire Guide
Part Number
KP2531-1
KP2531-2