Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Open the case side door.
2.
Slide the connector end of the gun and cable
through the hole in the machine front and into the
gun connector bushing on the wire drive.
3.
Make sure the gun connector end is seated fully into
the wire drive and tighten the thumbscrew to secure
.
the gun
4.
Plug the gun trigger lead connector into the 4 pin
gun trigger receptacle on the machine front.
5.
Wire Drive Polarity. MIG welding requires positive
(+) polarity. Connect the short power cable from the
wire drive to the positive (+) output terminal and
tighten the thumbscrew.
6.
Work Lead Connection. Slide the lugged end of the
work cable through the hole in the machine front
and place on the negative (-) output terminal and
.
tighten thumbscrew
Load Wire Spool
1.
Locate the green labeled 102mm diameter spool of
0.6mm L56 Solid MIG wire and place onto wire
spool spindle. Orient the spool so that the wire
feeds off the top of the spool.
2.
Secure spool in place by tightening the wing nut
against the against the spacer that holds the wire
spool on the spindle.
3.
Open the top drive roll pressure arm by rotating the
tension adjustor arm down and pivoting the drive roll
pressure arm up.
4.
Remove the outer wire guide.
5.
Slide gun out of drive slightly.
6.
Remove the lower drive roll and inner wire guide.
7.
Install the 0.6mm-0.9mm inner wire guide.
8.
Install the 0.6 mm smooth grooved lower drive roll.
9.
Carefully unwind and straighten the first six inches
of welding wire from the spool. Do not let the end of
the wire go to prevent the wire from unspooling.
10. Feed the wire through the wire drive inlet along the
inner wire guide groove and into the wire drive outlet
on the gun side.
11. Close the top drive roll pressure arm and secure by
pivoting the tension adjustor back to the up position.
12. Re-install the outer wire guide.
13. Remove the nozzle from the gun and contact tip and
straighten the gun out flat.
14. Turn the machine power to on and depress the gun
trigger to feed the wire through the gun liner until the
wire comes out of the threaded end of the gun
several inches.
A-7
Werbung
Inhaltsverzeichnis
