SUNTEC KLIMATRONIC TRANSFORM 9.000 Eco R290 Bedienungsanleitung Seite 22

Trouble shooting
Problem
1. Unit is not starting.
2. It's not cool
enough.
3. Unit is too loud.
4. The unit restarts
frequently.
5. The unit is not
cooling/heating.
6. There's a smell
coming from the unit
when operating.
7. How to increase
the efficiency?
8. E0 Code
9. E2/E4 Code
10. E3 Code
Spare parts and accessories supply (fast convenient supply)
You can obtain spare parts and accessories for your TRANSFORM R290 unit from your local dealer.
And at our website
you will find further information on individual accessory products as well as information on obtaining
our spare parts quickly and conveniently. You will also find other information (e.g. FAQ, lists of spare
parts, document download, etc) on your TRANSFORM R290 unit.
To check/Causes
Does the power supply have electricity?
Did you plug it in?
Are the doors and windows closed?
Are there heat sources in the room?
Is the exhaust hose installed and not
blocked?
Did you set the ventilation speed?
Is the ground even and flat?
The sound comes from the flowing of
the refrigerant inside the unit.
Is the voltage normal?
Is the exhaust hose curved?
Did you let the unit rest at least 24 hours
after moving it?
Production-related cause or incorrect
storage of the device, e.g. in dusty
places.
External circumstances exist which imay
impact the efficiency of the unit. Room
insulation, use of wall/window adapters,
ratio of window space (solar radiation),
operation of electrical units in the room,
presence of several persons in the room.
Room temperature sensor is not
working.
Water tank is full.
Coil sensor is not working.
www.suntec-wellness.de
Actions
Make sure to use a functioning power
socket.
Plug the unit in.
Close all doors and windows. The most
effective and saving way of cooling is to
not let any heat enter the room.
Remove the heat sources if possible.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Set the speed higher.
Place the unit on an even and flat surface.
None, this sound is normal.
Determine if the voltage is maintained at
rated voltage.
Straighten the exhaust hose.
The unit must be placed upright for at least
24 hours after every transport. Otherwise
the compressor may be damaged and
there is no capacity.
Odour can develop during initial start-up
after a long period of non-use due to
storage in unsuitable areas (e.g. dusty
places). Let the device run for half a day.
The smell disappears after a while. If
there's intense smell, ventilate the room.
You can increase the efficiency by
adjusting the described
accordingly.
Let the sensor be replaced. The unit can
also work without a new sensor.
Empty the water tank.
Let the sensor be replaced. The unit can
also work without a new sensor.
factors