SUNTEC KLIMATRONIC TRANSFORM 9.000 Eco R290 Bedienungsanleitung Seite 18

•
Control panel:
•
Remote control:
•
Environmental temperature for cooling function: 18°C – 35°C
Environmental temperature for heating function: 15°C – 25°C
•
Make sure that the exhaust hose is installed properly before operation, then plug in the unit, but do not
use a multiple socket. Press „POWER" to turn on the unit. When pressing the button again, the unit will
enter the standby mode.
•
LED display:
The LED display indicates the set temperature in °C or the set timer. Possible error codes are
o
also shown on the LED display.
•
Operation mode cooling:
When the refrigeration function is carried out, the exhaust hose should be placed outside the
o
window so that the hot air can be discharged.
Press „MODE" until the indicating light for cooling lights up.
o
Press the buttons „UP" und „DOWN" to adjust the desired room temperature between 17°C und
o
30°C.
For optimal cooling, make sure that curtains are closed to avoid direct sunlight entering the
o
room. Ensure that the unit is not placed near heat sources.
•
Operation mode heating:
Press „MODE" until the indicating light for heating lights up.
o
Press the buttons „UP" und „DOWN" to adjust the desired room temperature between 15°C und
o
25°C.
•
Ventilation speed:
Press the button „SPEED" to adjust the ventilation speed between low, medium, high and auto
o
mode. The according speed levels are indicated by the indicating lights at the control panel.
Note: During dehumidifying function the ventilation speed cannot be adjusted and stays at low
o
speed.
1. On/Off („POWER")
2. Temperature – („DOWN")
3. Operation mode („MODE")
4. Timer („TIMER")
5. Temperature+ („UP")
6. Ventilation speed („SPEED")
Indicating lights operation modes:
7. Dehumidification
8. Cooling
9. Heating
10. Signal receiver remote control
Indicating light ventilation speeds:
11. Medium
12. High
13. Auto mode
14. low
15. LED-display
1. SPEED: Ventilation speed
2. TEMP+: Temperature +
3. MODE: Operation mode
4. TEMP-: Temperature -
5. TIMER: Timer
6. POWER: On/Off button
Operation with 2 x AAA batteries (excl. scope of delivery)