SUNTEC KLIMATRONIC TRANSFORM 9.000 Eco R290 Bedienungsanleitung Seite 17

Parts description
1. Control panel
2. Air outlet
3. Exhaust hose connection
4. Comfort S Control Kit connection
Exhaust hose installation
•
Place the unit on a flat surface near a power socket, but at least 50cm between the filter side and other
objects. Keep the exhaust hose straight and do not pull it longer than 40cm (see pic.1).
•
Connect the exhaust hose adapter with one end of the exhaust hose by turning and fix the other end at
the unit's exhaust hose connection, also by turning.
•
Depending on your type of window, insert the window kit horizontally or vertically into your window. Lead
the exhaust hose through the hole at the window kit (see pic.2)
Pic. 1
Operation
•
After switching on or switching over, the fan runs. The compressor and cooling capacity start as soon
as the set temperature in cooling mode is lower than the room temperature. During heating mode the
compressor and heating capacity start as soon as the set temperature is higher than the room
temperature.
•
To not damage the compressor, wait at least 3,5 minutes before turning on the unit.
•
Operating voltage: 220-240V~, 50Hz
5. Drainage hole
6. Filter
7. Air inlet for cold air
8. Air inlet for hot air
Pic. 2