SUNTEC KLIMATRONIC TRANSFORM 9.000 Eco R290 Bedienungsanleitung Seite 21

The cold extract air has to be led out of the room via the air hose. This can be executed e.g. via a tilted
window, a door or wall aperture. Make sure that no cold outside air can enter the room. For effective heating,
we recommend our selection of various accessories which reduce or prevent entry of cold air into the room.
Set the function to „Heating". The settable temperature range is between 15°C and 25°C target temperature.
You can set this using the temperature control.
HEATING IN OUTDOOR OPERATION
The unit is outside the room to be heated. Outdoor operation is ideal for the transition period in which outside
temperatures do no fall below 7°C. (If the outside temperature should however fall below 7°C continuously,
we recommend indoor operation). Connect the air hose and the air outlet grid to the unit as displayed in the
illustration, the air hose connection piece and air outlet grid need to be exchanged.
Set the function to „Heating". The settable temperature range is between 15°C and 25°C target temperature.
You can set this using the temperature control.
The air with high oxygen content heated by the unit is fed into the room via the air hose. This can be executed
e.g. via a tilted window, a door or wall aperture. Make sure that no cold outside air can enter the room. For
effective heating, we recommend our selection of various accessories which reduce or prevent entry of cold
air into the room.
Using the "Comfort Control- S Kit" (see segment accessories) you can also control the unit from inside using
the remote control.
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth and neutral detergent and then wipe dry
with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
•
Clean the dust filter once every two weeks. To do so, pull out the dust filter at the unit's side with the
help of the dust filter handle (see pic.4). Clean the dust filter with neutral detergent and about 40°C
water. Rinse off any detergent, then let it air-dry before inserting it back into the unit.
•
If you do not use the unit for a longer time, empty the water tank completely (see segment „water tank").
Make sure that the unit is disconnected from the power supply and that it is clean. Keep the unit covered
in a dry place.
Staubfiltergriff
Pic. 4