Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning and maintenance
• Attention: Hazard of injury!
• Always unplug the appliance before cleaning!
• Never immerse the base unit, power cord and the mains plug
in water or clean them under running water!
• Do not reach into the sharp cutting inserts with your hands!
• The fixing brackets of the pusher are pointed and may be
sharp-edged!
• Handle cutting tools with care to avoid injuries!
• Note: All detachable accessory parts may also be cleaned in the dishwasher at low temperature and in the
upper dish rack. However we recommend to clean them by hand as the cutting inserts may become dull in
the dishwasher in short time.
• Clean the appliance immediately after use so that residues do not dry on.
• Remove all detachable parts from the base unit.
• Clean the outside of the base unit with a damp tissue and wipe it dry.
• Clean all detachable accessory parts using hot water with some mild detergent. For cleaning of the cutting
inserts, use the enclosed cleaning brush.
• Prior to the next use, all accessory parts have to be completely dry.
• Do not use any abrasives or solvents!
• Never use a steam jet appliance for cleaning!
Troubleshooting
Error
Appliance without function
Spirals are uneven
Spirals are unappealing
Food spinning in the pusher
Appliance stops during operation
Cause and corrective actions
o
Check whether the mains plug is connected to the socket.
o
If necessary check by means of another device if the socket
functions properly.
o
Check whether the appliance is assembled properly and thus
both safety switches are activated.
o
Check whether the food has been fixed properly and tightly
on the pusher.
o
Too much pressure has been applied on the pusher, try again
with less pressure to the pusher.
o
Too little pressure has been applied to the pusher, try again
with more pressure to the pusher.
o
The food is too soft and therefore not suitable to be processed
in the spiral slicer.
o
Possibly the blades of the cutting inserts are blunt, in this case
exchange the inserts.
o
The food is too hard and therefore not suitable to be
processed in the spiral slicer.
o
Check whether the cutting insert is clogged. In this case clean
the insert and start the appliance again.
23
Werbung
Inhaltsverzeichnis
Fehlerbehebung
