How To Start / Stop The Appliance; How To Start Processing Food; Food Separates From Pusher; How To Switch Off The Appliance Completely - Rommelsbacher EGS 80 Bedienungsanleitung

Lock the cutting
insert holder by
slightly turning it into
direction 'CLOSE'.

3.) How to start / stop the appliance

IMPORTANT: Before fitting the base unit to the collecting container, please check whether the appliance
has been switched on unintentionally!
• To do so, remove the base unit from the collecting container.
• Then plug the mains plug into a power socket.
• If the operation pilot lamp lights up, the appliance is switched on. In this case switch off the appliance by
pressing the ON/OFF switch. The operation pilot lamp turns off.
• After you are sure that the appliance is switched off, you can put the base unit on the collecting container.
NOTE: The appliance is designed for short-term operation only resp. for a maximum continuous operation
time of 2 minutes. After this time limit is reached, allow the appliance to cool down for at least 2 minutes.
If this is not respected, the motor may be damaged!
• To start, press the ON/OFF switch. The appliance starts and the pilot lamp lights up continuously.
• To stop, press the ON/OFF switch once again. The appliance stops and the pilot lamp turns off.

4.) How to start processing food

• Put the food to be cut in the centre of the pusher and press firmly. This is important in order to be able
to apply an even pressure on the food.
• Insert the pusher with the attached food into the feed chute.
• Start the appliance by pressing the ON/OFF switch.
• Only apply a gentle and even pressure to the pusher to push the food downwards.
• Always firmly hold the pusher during the slicing process.
• Switch the appliance off during reloading the pusher.
• Empty the collecting container from time to time.
5.) Food separates from the pusher
• Should a piece of food separate from the pusher during operation, stop the appliance by pressing the
ON/OFF switch.
• Disconnect the mains plug from the socket before removing residues from the cutting insert.
• Remove residues from the cutting insert and put the food on the pusher once again.
• Then restart the processing.
6.)

How to switch off the appliance completely

• Pull the power plug after each use for safe switch-off!
22
Put the feed chute
into the corresponding
slots on the base unit.
(This can be done in 3
positions).
Lock the feed
chute by turning
it to the right into
direction „locked
lock", until it audibly
engages.
Insert the pusher into
the feed chute.
Put the collecting
container on the base
unit. Pay attention
that the safety switch
is correctly positioned
above the container.