How To Fill The Removable Stainless Steel Dish; Connecting The Appliance To The Power Supply; Operation With Manual Control; (Offline Without App) - Rommelsbacher HB 100 HeatsBox Bedienungsanleitung

How to fill and insert the removable stainless steel dish
• Unlock the casing cover and lift it.
• Remove the stainless steel dish and place it on a flat surface.
• Fill the prepared food into the stainless steel dish. Please observe the maximum filling quantity (marking).
• Place the stainless steel dish on the heating surface in the inner housing of the appliance.
• Close the casing cover and lock it with the locking clips. Pay attention to correct barring.

Connecting the appliance to the power supply

• Insert the power cord (connector) into the port on the back of the appliance. Pay attention to a firm and
correct fitting of the power cord. If the power cord is too loose, this may result in damages at the cable
and the plug!
• Connect the power plug with a sufficiently secured socket.
• The appliance is in standby mode.
Operation with manual control (offline operation without app)

Start the heating process

• Press the ON/OFF button for one second.
 Operation pilot lamp lights up permanently in WHITE colour.
• The appliance is in operating mode.
NOTE: If the operation pilot lamp is flashing in WHITE, the casing cover is not locked correctly. As
soon as the casing cover has been locked correctly, the operation pilot lamp lights up permanently in
WHITE colour.
NOTE: If there is no further operation within 18 minutes after switching on, the control unit switches
back to standby mode and the operation pilot lamp expires.
• Press the ON/OFF button once again for one second to start the heating process.
 Operation pilot lamp lights up permanently in RED colour.
NOTE: If the operation pilot lamp is flashing in RED, the casing cover is not locked correctly. As soon as
the casing cover has been locked correctly, the operation pilot lamp lights up permanently in RED colour.
• The appliance heats up the food in the stainless steel dish to approx. 75 ° C. This takes between 20
and 30 minutes, depending on the quantity and consistency of the food.
• You can open the casing cover at any time during the heating process to stir or to check the
temperature of the contents. After closing, the heating process continues automatically.
• Once the temperature has been reached, the appliance switches to keep warm function for 30 minutes.
 The operation control lamp lights up permanently in GREEN colour.
• After the heating process has ended, the appliance switches back to standby mode.
 The operation pilot lamp expires.

Premature stop of the heating process

• You can stop the heating process by pressing the ON/OFF button continuously for 3 seconds.
20