EINHELL ALPHA-TOOLS BKG 1800 Bedienungsanleitung Seite 14

Anleitung BKG 1800 SPK7
GB
to check that its safety devices and any slightly
damaged parts are working properly and in the
way intended.
Check that the moving parts work properly and
do not jam or whether any of the parts are
damaged. All parts must be fitted correctly and
satisfy all conditions for the tool to work properly.
Unless otherwise stated in these instructions,
damaged safety devices and parts must be
repaired or replaced by experts in an approved
specialist workshop.
Have damaged switches replaced by a customer
service workshop.
This tool complies with the pertinent safety
regulations. Repairs are to be carried out only by
qualified electricians using original replacement
parts. The user may suffer an accident if this
condition is not observed.
Be careful when making vertical cuts.
Take special care when making double miter
cuts.
Do not overload the tool!
Wear safety goggles.
Use a breathing mask on dusty jobs.
Check the tool's power cable / extension cable
for damage.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, E Din EN 31201; 6/93,
ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be introduced
for the user (ear-muffs).
Idle speed
Sound pressure level LPA 89,2 dB(A)
Sound power level LWA 102,2 dB(A)
14
10.01.2006 16:43 Uhr Seite 14
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."
5. Technical data
Asynchronous motor
Output
Operating mode
Idle speed n
0
Carbide-tipped saw blade ø 250 x ø 30 x 3.2 mm
Number of teeth
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Weight
6. Before putting the machine into
operation
The machine must be firmly mounted in working
position, e.g. on a workbench, the base frame
supplied with the machine, or similar.
All the covers and safety devices have to be
properly fitted before the machine is switched on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
230 V~ 50 Hz
1800 W
S1
4600 min -1
60
-45° / 0° / +45°
0° to 45° to the left
305 x 75 mm
210 x 75 mm
210 x 45 mm
18 kg