Scope Of Delivery; Specialist Installer Qualification; Intended Use - Maico ECO 30 E Montage- Und Betriebsanleitung

ECO 30 E, ECO 40 D
Please read the instructions carefully
before mounting and using for the
first time. Follow the instructions.
Pass these instructions onto the
owner for safekeeping.
Unit overview: Fig. A and B
1 Impeller
2 Protective cage
3 Cover
4 Cable grommet
5 Bearing bracket
6 Gear motor with capacitor [6.1]
7 Fan motor
8 Bearing bushing - bracket (right/left)
9 Bearing bushing - eccentric lever
10 Motor housing
11 Eccentric disc
12 Pin with retaining ring [12.1]
13 Eccentric lever of swivel drive
14 Drive axis
Dimensions: Fig. C
Assembly process: Fig. D to I
UP recessed-mounted
AP surface-mounted
15 Capacitor ECO 40 D
16 Holder
17 Terminal block with two screws [17.1]
Table of contents
1. Scope of delivery ................................... 11
2. Specialist installer qualification ............... 11
3. Intended use .......................................... 11
4. Safety instructions and warnings ............ 12
5. Operation ............................................... 14
6. Environmental conditions and operating
limits....................................................... 14
7. Technical data ........................................ 14
8. Transport ............................................... 14
9. Storage .................................................. 14
Table of contents │ UK
10. Mounting information ............................ 14
11. Mounting ............................................... 15
12. Commissioning ..................................... 15
13. Maintenance ......................................... 16
14. Cleaning ............................................... 16
15. Fault rectification ................................... 16
16. Spare parts ........................................... 16
17. Dismantling ........................................... 17
18. Environmentally responsible disposal ... 17

1. Scope of delivery

ECO wall fan, two M3x12 screws for the
terminal block, two washers, two plastic caps,
these installation and operating instructions.

2. Specialist installer qualification

Mounting may only be carried out by specia-
lists who have the necessary knowledge and
experience in ventilation engineering.
Only a trained electrician is permitted to
work on the electrics. You are deemed a
trained electrician if you are familiar with the
relevant standards and guidelines, can
competently and safely connect units to an
electrical power supply in line with the
attached wiring diagram and are able to
recognise and avoid risks and dangers
associated with electricity on the basis of
your technical training and experience.

3. Intended use

This axial industrial fan serves as a wall fan
for air circulation in commercial premises,
production sites, restaurants, workplaces,
showrooms etc.
During operation, the fan swivels (oscillates)
back and forth (swivelling range 55°, 70°, 90°
or 115° - adjustable at the time of installation).
ECO 30 E with an impeller diameter of
300 mm, ECO 40 D with an impeller diameter
of 400 mm. Fan motor and swivel gear's drive
can be switched separately.
Acknowledgements: © Maico Elektroapparate-
Fabrik GmbH. Translation of the original German
instructions. Misprints, errors and technical
changes are reserved.
11