Recommendations; Torques Specifications; Suspension Forks; Specific Models - Lapierre CARBON Bedienungsanleitung

PAGES_INTER2013V2.indd 11

3 RECOMMENDATIONS

3.1 - TORQUE SPECIFICATIONS
- classic stem = 20 nm
- Handlebars on a classic stem = 25 nm
- threadless headset = 10 nm on the pivot and 5 nm on the handlebars
- Brake cables = 6-8 nm
- Brake pads = 6-8 nm
- Brake levers = 6-8 nm
- rear derailleur = 8-10 nm
- front derailleur = 5-6 nm
- shifters = 5 nm
- Wheelnuts = 20 nm
- saddle clamp = 15 nm

3.2 - SUSPENSION FORKS

your suspension fork requires specific, precise maintenance that may vary depending on the fork. it is
imperative that you read the manufacturer's notice that is delivered with your bike. due to the impact and
the shocks that suspension forks absorb, it is important to clean the stanchions and inspect the joints after
each use. Please refer to the manufacturer's notice for information regarding how often you should change
or add oil. only a specialist who has the proper tools should perform these operations.
III - SPECIFIC MODELS

1 - CARBON MODELS

our carbon frames are the result of long hours of research and development, and owning one requires
certain maintenance procedures that will prolong the life of your bike and assure optimal performance.
- Pay close attention to your bike, listening for any strange noises and visually inspecting the frame and
parts on a regular basis.
- Perform regular tune-ups:
• Periodically visit your authorized lapierre dealer so he can inspect your bike.
• in case of any serious accidents, have your bike examined by an authorized lapierre dealer before riding it again.
• avoid using grease on your seat tube as certain ones can be harmful to the resin and deteriorate it.
• during winter rides, it is absolutely necessary to wash your bike after each ride in order to avoid damaging
the frame from the salt.
II - SETTINgS
SETTINgS - 11
14/05/2013 10:58:50