Forward Movement; Reverse Movement - Columbus BM 62 Bedienungsanleitung

Vacuum sweeper
AKS 70|BM 62
CHAPTER 10 – CHECK TO BE MADE BEFORE STARTUP
1 - Check the level of the battery solution and if necessary top up with distilled water.
2 - Make sure the connector Part. 1 Fig. 13 is well inserted in the socket Part. 2 Fig. 13.
CAPITOLO 11 – STARING AND STOPPING
IMPORTANT: To start the machine, first of all sit in the driver's seat. If the operator is not sat, or if he/she stands up during start up, the
START UP :
Turn the key Part. 6 of switchboard clockwise
Turn the switch Part. 5 of switchboard to start the engine, the rotation of brushes and to activate suction.
The machine is in working position with the central brush lowered and suction engaged.

FORWARD MOVEMENT:

Position the switch Part. 1 of switchboard forwards and press the forward pedal with the foot Part. 6 Fig. 2.

REVERSE MOVEMENT:

Position the switch Part. 1 of switchboard backwards and press the backward pedal with your foot Part. 6 Fig. 2
NEUTRAL:
With the switch Part. 1 of switchboard in central position the machine is in neutral.
STOP:
Turn the switch Part. 5 of switchboard anticlockwise
Turn the key Part. 6 of switchboard anticlockwise.
CHAPTER 12 – CORRECT USE AND ADVICES
IMPORTANT: Before starting work, make sure there are no strings, plastic or metal wires or long strips of cloth, sticks, power leads, etc. on the
floor as theY are hazardous and could damage the dust seals and brushes. These must be removed before starting work with the machine.
Be very careful when driving over rails, door runners, ets. These can cause damage to dust seals. Drive over them very slowly.
Avoid driving over puddles of water. In the presence of damp surfaces, close the suction by means of knob Part. 1 Fig. 6 located to
the right of the operator, alongside the central brush start lever.
In the presence of large or lightweight objects (leaves, cigarette boxes etc.) lift the front flap by pressing the flap-lift pedal with the
heel of your left foot Part. 1 Fig. 9.
If the surface to be cleaned is very dirty in terms of quantity and quality of the material or dust to be picked up, first of all go over
the area "roughly" without paying too much attention to the result. Then with a clean bin and the filters well shaken, go over it
again. This way, the desired effect will be achieved.
Subsequently, if the machine is used regularly and properly, such "rough" cleaning will no longer be required.
The side brush must only be used for cleaning edges, profiles, corners, etc. It must be raised (disengaged) immediately after use so it
does not lift up dust and also because results achieved with the side brush engaged are always inferior to those obtained with the
central brush alone.
For good results, empty the container regularly and keep the filters clean, shaking them with the tools provided.
BEFORE PROCEEDING MAKE SURE YOU HAVE READ ALL PREVIOUS CHAPTERS.
ATTENTION PLEASE:
machine will stop.
26