Overheating Protection; Frost Protection Function; Topple Over Protection - Silvercrest SWW 1500 A1 Bedienungsanleitung

Handling and operation
♦ Whilst the preset time is blinking in the display
+/-
hours.
♦ After 5 seconds the indicator in the display
temperature.
♦ Whilst the nominal temperature is blinking in the display
the buttons +/-
15°C - 35°C.
♦ After 5 seconds the preset switch-on time is shown continuously in the
display
♦ When the switch-on time arrives and the room temperature is below the set
nominal temperature, the appliance switches on with the higher heating
power (HIGH).
♦ Press the button AUTO ON
the switch on time. In the display

Overheating protection

With excessive temperature rise the device automatically switches off and in the
display
Should this occur...
♦ Switch the device off at the main switch POWER
plug from the wall socket. Allow the device to cool down for a few minutes
♦ After the cause of the overheating has been removed, i.e. a covered heating
element, the device can be switched on again.

Frost protection function

The device is equipped with a frost protection function which automatically switches
to the high heat output (HIGH) as soon as the room temperature falls below 7°C.
When the room temperature has reached 10°C the appliance automatically
switches back to standby mode.
♦ Activate the main switch POWER
into standby operation. In the display
function
The device now switches on if the room temperature drops below 7°C.
In the display

Topple over protection

The device is equipped with topple over protection which automatically switches
the heating element
sounds for 1 minute.
SWW 1500 A1
and/or to set the desired switch on time between 1 hour and 24
4 13
resp. , to set the desired nominal temperature from
4 13
and the settings are taken over.
appears .
lights up.
the symbol for the frost protection function
off if the device topples over. In addition a warning tone
9
press one of the buttons
changes to set the nominal
and/or again if you want to deactivate
11
2
the indicator AUTO ON
and pull the mains power
6
6 to switch the device on and to shift
the symbol for the frost protection
, press one of
goes out.
blinks.
13
GB
IE