Overheating Protection; Tilt Cut-Out; Cleaning - Silvercrest LHL 2000 B1 - IAN 100108 Bedienungsanleitung

Overheating protection

The appliance is fi tted with a overheating protector. Should the appliance become
too hot internally, the heating element switches itself off automatically. Once
the appliance has cooled itself down, the heating element switches back on
automatically.
WARNING
As a general rule, overheating has a reason! It can mean a risk
of fi re!
► Check that the appliance can suffi ciently disburse the heat generated:
Is the appliance covered or is it too close to a wall or other obstacle?
Are the grilles on the front or back clear? Is the ventilator blocked?
► If possible, eliminate the problem or contact the Service Hotline
(see Chapter Service).
► Even if you cannot fi nd a cause, but the overheating protection triggers
a second time, you must return the appliance to Customer Services for
inspection or repair.

Tilt cut-out

This Fan Heater is fi tted with a safety switch
switches itself off automatically. The Fan Heater fi rst switches itself on again when
it is in an upright position and the safety switch

Cleaning

WARNING
Observe the following safety information to avoid risks and property damage:
► Only clean the appliance when it is switched off and cold.
IMPORTANT
Possible damage to the appliance.
Penetrating moisture can lead to the appliance becoming damaged.
► When you are cleaning the appliance ensure that no moisture can get
inside, so as to avoid irreparable damage to it.
■ Clean the housing exclusively with a soft damp cloth and a mild dishwashing liquid.
■ Remove dust deposits on the protective screen with a vacuum cleaner.
LHL 2000 B1
3 . Should the Fan Heater tip over, it
3 is actuated.
GB
9