Technical Data - Sanitas SMA 70 Gebrauchsanleitung

A complete set of all seven attachments can be ordered from the service address under order numb-
er 162.563.
6. cleaning
Warning! Before cleaning, always unplug the device from the mains.
Warning! Beware of life-threatening electric shock: Never submerge the device in water or other
liquids.
• Clean the device with a slightly moistened cloth. In case of more extreme soiling you can also moisten the
cloth with mild soapy water.
• Clean the attachments after every use to prevent transmission of fungus and other infections to other parts
of the body.
• Use a toothbrush to remove stubborn callus and skin fragments.
• If necessary, clean the attachments with a cloth or brush moistened with disinfectant spray or 90 % alcohol
(obtainable from pharmacies). Then dry the attachments thoroughly.
• Do not use any chemical cleaners or abrasive agents for cleaning.
• Ensure that no water penetrates into the device. If this should ever happen then only use the device once
it is completely dry.
7. Disposal
The appliance should be disposed of according to EC Directive 2002/96/EC-WEEE (Waste Electrical
and Electronic Equipment). In case of queries, please contact the municipal authorities responsible
for waste disposal in your area.

8. technical Data

Nominal voltage:
Rated output:
Speed:
Short operation:
Dimensions (LxWxH):
Weight:
cylindrical milling cutter
Removing hardened toenail surfaces and coarse smoothing. Place the cylindrical mil-
ling cutter horizontally on the nail surface and remove the nail layer with slow rotary
movements.
Flame milling cutter
For removing ingrown nails. Insert the flame milling cutter carefully to the point of
interest and remove the appropriate parts of the nail.
Sapphire milling cutter
This attachment is used for careful removal of warts. If you use this attachment, remem-
ber that it is very quick and easy to cut into the skin deeper by accident and injure the
skin over the bone.
100–240 V ~ 50/60 Hz
10 W
Level 1: 3500 +/- 600 rpm
Level 2: 5100 +/- 800 rpm
max. 20 min.
28x23x8 cm
approx. 1 kg (without packaging)
12