Scope Of Supply; Putting Into Operation - Sanitas SMA 70 Gebrauchsanleitung

15 16 14

3. Scope of supply

Check that the device and accessories are complete immediately after unpacking and make sure that the
device is undamaged.
1 x tabletop device
1 x felt cone
1 x sapphire cone
1 x sapphire callus sander
1 x sapphire wheel
1 x cylindrical milling cutter
1 x flame milling cutter
1 x sapphire milling cutter
1 x Instructions for Use

4. Putting into operation

Open the compartment on the bottom, remove the power plug and extend the power cord to the desired
length. No turn the device right side up and place on your work surface (such as a smooth table). Press
the device lightly to the work surface from the top to set the suction cups that hold the device in position
during operation.
Open the device by pressing the catch. Take the handle out of its holder.
Fitting attachment
• Select the desired attachment and insert it into the handle of the device. The attachments must be inserted
until you can feel then lock into position.
• Make sure that the rotary switch is in the OFF position "0" before plugging in the power plug.
• Plug the power cord into the mains outlet. The device is ready for use (display lights up).
Removing attachment
• Turn the rotary switch to the OFF position "0".
• Disconnect the mains plug from the wall socket.
• Pull the attachment straight out of the handle.
5. Application
!
Important! Check the results regularly when using the device.
This is particularly important for diabetics, because their hands and feet are less sensitive.
note: Do not pretreat yourself in the water bath.
The attachments are less effective when the skin is softened or wet.
• Do not exert strong pressure and always move the attachments carefully over the surface that you are
treating.
on the bottom of the device:
14 Suction cup
15 Power cord (in cord winder)
16 Compartment for power plug
10