Residual Risks; Warranty Conditions - Dynamic24 OS220 Gebrauchsanleitung

❐ Warning: If the saw blade or scraper catches during use or is improperly aligned, this may
result in kickback. This may cause the device to lift up and the motor output may propel it
back towards the operator. To prevent kickback, the following precautions should be taken:
– Hold the device fi rmly and position your arms so that you are able to absorb kickback
forces.
– Always position your body to the side of the device and never in line with it.
– If the saw blade or scraper jam or if you interrupt work, set the On / Off switch to the 0
position and hold the device fi rmly until the adapter has come to a stop. Never attempt
to remove the device from the workpiece or pull it back while the adapter is moving.
Determine and rectify the cause of the jam.
– Support large workpieces on both sides: Both in the vicinity of the work area and along
the borders.

Residual risks

❐ The following residual risks may exist even if the device is used properly and in the event of
compliance with all safety notes in these instructions:
– Touching the saw blade or scraper (cut injuries)
– Reaching into the rotating saw blade or the scraper (cut injuries)
– Unforeseeable, sudden movement of the workpiece (kickback risk)
– Separation / projection of parts from the workpiece (risk of injury if insuffi cient protective
clothing is worn)
For this reason, always handle the device in an attentive and careful manner!

Warranty conditions

Defects arising due to improper handling, damage or attempts at repair are excluded from the
warranty. This also applies to normal wear and tear.
25