Setting The Dispensers - Electrolux ZUCI Installation, Bedienung Und Wartung

the wash cycle (see paragraph "Setting the dispen-
sers").
Figure 15
• Connect the rinse-aid dispenser between termi-
nals 8 and 9. These connection points are live
during filling of the tank and at the end of the rinse
cycle for a set time (see "setting the dispensers"
paragraph).
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it
may be necessary to activate the dispensers manually
in order to fill the hoses and eliminate any air.
Simultaneously press the buttons, as shown in the
figures below. If necessary, repeat this operation seve-
ral times.
1 2 3
DETERGENT DISPENSER
In the appliances with pressure boiler, the diaphragm
dispenser pump may be manually activated by pres-
sing screw "D" (Figure 13).
B5

SETTING THE DISPENSERS

1) Peristaltic dispensers
All operations should be carried out with the appliance
switched on, the door open and no cycle selected.
LEGEND
Increase
Decrease
Confirm or select next parameter
SEQUENTIAL START
Press the indicated buttons simultaneously for 5
seconds:
10
1 2 3
DISPENSER RINSE-AID
1
Display of programming mode:
GEn
Initial amount of detergent:
Setting the activation time:
45
45
Initial amount of rinse-aid:
Setting the activation time:
10
Amount of detergent during the cycle:
Setting the activation time:
8
Amount of rinse-aid during the cycle:
Setting the activation time:
4
Exit from programming mode:
Notes for external dispensers:
- if the detergent dispenser only ope-
rates during wash pump operation; terminals 7-9
of the main terminal board are powered at the
same time.
1 2 3
dln
1 2 3
rln
1 2 3
dEt
1 2 3
rAl
1 2 3
GEn