Converter Buttons - Grundfos MP 1 Bedienungsanleitung

6.2 Converter buttons

The converter buttons are used to change control parameters, to
operate the MP 1 pump and to change over between the displays
in order to monitor the status of the pump.
Some of the buttons incorporate indicator lights.
[F1]
Press [F1] to enter the
programming mode.
The converter is factory-set.
DO NOT CHANGE THE SETUP!
[MENU/ESC]
When [MENU/ESC] is
pressed, a menu with six
items appears:
STATUS
QUICK SETUP
PROGRAMMING
EVENT LOG
DIAGNOSTICS
DISPLAY OPTIONS
Press [MENU/ESC] again to
return.
[REV]
Press [REV] to reverse the
direction of rotation of the
motor.
[JOG]
[JOG] is disabled.
Converter buttons
Fig. 9
* For possible display texts, see page 62.
8
Indicator light
[FWD] button (green)
[REV] button (green)
[STOP] button (red)
Arrow buttons
Press [ ] to increase and [ ] to decrease
the value of the displayed parameter.
Press [ or [ to move the cursor between
] ]
the digits.
[STOP]
Press [STOP] to stop the motor.
Description
The indicator light is on when the motor
rotates in the forward direction.
The indicator light is on when the motor
rotates in the reverse direction.
The indicator light is on when [STOP]
has been pressed.
[F2]
Press [F2] to reset the converter.
[ENTER]
In the display mode, [ENTER] is
used to directly set the desired
speed.
[LOCAL/REMOTE]
The converter must always be in
LOCAL mode.
[HELP]
Provides help for each
display, setup parameter and
fault*.
Press [HELP] to view/close
the help function.
[FWD]
Press [FWD] to start the pump
(forward direction of rotation).