Pan Detection; Indication Of Residual Heat; Power Function - Novy One Power Bedienungsanleitung

Switching a cooking zone on and off
Set up
Press the cooking zone selection button.
Switch off
Press the cooking zone selection buttons
and simultaneously until the display shows
or = "hot".
0 H
If there is no control input within 20 seconds, the electronics will
return to the wait position.

4.1.3 Pan detection

The cooking zone that has been switched on is only active
when a cooking pan is detected by the pan detection system.
The induction hob does not work:
– If there is no pan on the cooking zone or if the pan is
unsuitable for induction. In this case, it is impossible to put
the power on and the symbol will flash on the display.
– The operation is suspended when the pan is removed from
the cooking zone during cooking. The
on the display. The symbol will disappear when the pan is
placed back onto the cooking surface. The cooking will then
continue at the same power level as selected previously.
Switch off the cooking zone after use.

4.1.4 Indication of residual heat

After the cooking zone or hob has been switched off completely,
the hob glass will still be warm, which can be seen by
symbol disappears when the cooking zone glass can be
H
handled without danger.

WARNING: As long as the residual heat indication
remains active, the cooking zone(s) must not be
touched and no heat-sensitive items should be
placed on the cooking zone. Risk of fire and burns.

4.1.5 Power function

Power function
Display
zone. If this function is activated, these cooking zones will be
00 subjected to considerably higher power for 10 minutes.
The Power function is designed to quickly heat large quantities
of water, for pasta for example.
0
H
Switch on power
Press the cooking zone selection button.
Press the
until P
Switch off Power
Press on the
Management of maximum power:
The hob is divided into 2 separate heating groups.
symbol will flash
. The
H
If this power limit is exceeded when switching to a high
selected cooking heat or switching the power function on, the
power management module reduces the cooking position of
the relevant cooking zone. This cooking zone will first flash,
and it is then automatically reduced to the maximum possible
cooking heat
Het maximale vermogen van de zones A1 en B2 is afzonderlijk
3000W en 1850W van de zones A2 en B1.
If simultaneous cooking is taking place on zones A1 and A2 or
B1 and B2, the power of 3700 W is divided between these 2
zones A1 and A2 or B1 and B2.
Cooking zone
A1
B2
B1
A2
– 60 –
boosts the power to the selected cooking
P
Switching Power on and off
button and then the
button
B2
B1
B2 A2
8 8
8 8
B1 A1
in cm Power (W)
24 x 20 Normal: 2100
24 x 20 Power: 3000
24 x 20 Normal: 1600
24 x 20 Power: 1850
Display
button P
9‐0
A2
A1