X-lite X-403GT Sicherheit Und Gebrauchsanleitung Seite 23

14.4. Repeat these steps with the padding of the right cheek pad.
WARNING: the buttons are not hooked until a click is heard. Check that the
strap comes out properly from the cheek pad.
WARNING
- If your helmet is equipped with the double D-Ring retention system, pull it
down as indicated in the attached double D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely reassembled.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner polystyrene components with a damp cloth only and allow it to
dry at room temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described
above.
15. Creating space for glasses
15.1. Remove the left cheek pad from the helmet (see instructions above).
15.2. Open the cheek pad at the top, partially remove the padding and remove the
die-cut part (Fig. 19), then refit the remaining padding in the cheek pad and
close it.
NOTE: it is recommended to keep the removed padding for any subsequent
reuse.
15.3. Refit the cheek pad on the helmet (see instructions above).
15.4. Repeat these steps with the right cheek pad.
16. Removing space for glasses
16.1. Remove the left cheek pad from the helmet (see instructions above).
16.2. Open the cheek pad at the top, reinsert the previously removed padding (Fig.
19) in the cheek pad and close it.
16.3. Refit the cheek pad on the helmet (see instructions above).
16.4. Repeat these steps with the right cheek pad.
WIND PROTECTOR
(Available as standard or as accessory/spare part).
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant air infiltrations under the chin.
See Fig. 20 for assembly and disassembly.
23