X-lite X-403GT Sicherheit Und Gebrauchsanleitung Seite 16

INSTRUCTIONS FOR USE
The X-403 GT helmet is fitted with a removable protective chin guard. It can be
used in different configurations thanks to the accessories included in the pack-
age, as described in Fig. 1.
Using the helmet in the configuration featuring the chin guard fastened and vi-
sor pulled down definitely guarantees a higher level of protection if compared
with the other possible configurations.
The chin guard locking slot covers - which must be assembled if the helmet is
used without chin guard - and the side plates - which must be assembled if the
helmet is used without visor - are included in the box.
VISOR
1. Visor disassembly
1.1. Open the visor completely.
1.2. Press and hold the visor release button (A) down and slide the visor forward
until it clicks (Fig. 2).
1.3. Free the visor fastenings (B1 e B2) from their housing (Fig. 3).
1.4. Follow the same steps on the other side of the helmet.
2. Visor assembly
2.1. Set the visor in open position by placing the visor fastenings (B1 and B2) in line
with the housings in the visor mechanism (Fig. 3).
2.2. Insert fastening B1 in the provided housing and press the visor against the shell
in line with fastening B2. This will push the visor release button (A).
2.3. Slide the visor backwards until the visor release button (A) clicks.
2.4. Follow the same steps on the other side of the helmet.
2.5. Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the vi-
sor, making sure that the mechanisms hold it in the different positions. If nec-
essary, repeat the above-mentioned steps.
- Do not use the helmet if the visor has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please refer to an
X-Lite authorized dealer.
REMOVABLE PROTECTIVE CHIN GUARD
3. Removable protective chin guard release
3.1. Open the visor completely.
3.2. Pull the right and left chin guard release levers downwards and at the same
time remove the chin guard from the helmet by pulling it outwards (Fig. 4).
16