Initial Operation; Preparation Of Coffee; Decalcification And Cleaning; Practical Hints - EFBE-SCHOTT KA 601.1 Gebrauchsanleitung

Fax +32 2 359 95 50
Never operate the appliance without water. Important: your jug cannot be put in the
microwave oven to warm up the coffee. We shall not be held responsible for any
damages caused by the non-observance of this instruction.
Never forget that the coffee coming out of the appliance is very hot. Only move the jug
very carefully to avoid splashing.
Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.

INITIAL OPERATION

•
For a perfect taste, carry out 2 or 3 boil processes with fresh water (without coffee). These
boil processes are absolutely necessary.
•
Once all the water has passed through, switch the appliance off and let it cool down
during 5 minutes. Then repeat the process with fresh water.

PREPARATION OF COFFEE

•
Open the lid of the water tank (6).
•
Pour the desired amount of water into the water tank. The number of cups can be read
from the glass jug and from the scale on the water tank as they show the levels for normal
cups (1 cup = 125 ml) and for small cups. Make sure not to overfill by filling water for
maximum 6 cups of coffee.
•
Use the supplied permanent filter or insert a paper filter (size 2) in the filter and add the
desired quantity of ground coffee (1 teaspoon per cup, approximately 6g).
•
Do not forget to close the lid before switching on your coffee maker.
•
Put the glass jug with closed lid on the hot plate.
•
To switch on the machine, put the switch in position "1". The control light of the switch will
light up, indicating that the appliance is working. The keep warm function makes it
possible to keep the coffee warm for as long as the coffee maker is switched on and the
jug is on the hotplate.
•
When the brewing process is over, remove the glass jug from the hotplate (a non-drip
valve prevents dripping) and pour the desired amount of coffee. Put the jug with the
remaining coffee back on the hotplate.
•
We advise you, however, to not let the appliance switched on for more than 2 hours. Also,
never leave an empty jug on the heated hotplate. The hotplate will be functioning until
the switch is put in the off-position – position „0".

DECALCIFICATION AND CLEANING

•
We advise you to descale the coffee maker regularly to prolong its life span. For descaling
only use products especially made for descaling of coffee makers and follow their
instruction manual. Then rinse the appliance twice with fresh water, without coffee
powder (2 brewing cycles). Guarantee claims will not be accepted for appliances that
have not been descaled.
•
Never use a dishwasher to clean the appliance or its accessories. Just clean the jug in
soapsuds.
•
To clean the plastic parts of the appliance, use a damp, non abrasive cloth.

PRACTICAL HINTS

When you notice that the coffee making process is longer than it should be, it is probably time
to decalcify the appliance. Do not wait until the situation gets worse. The decalcifying
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
9
Assembly page 9/20
SC KA 601.1 -111213