Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fax +32 2 359 95 50
Important: your thermos flask cannot be put in the microwave oven to warm up the
coffee or in the dishwasher to clean it. We shall not be held responsible for any damages
caused by the non-observance of these instructions.
Only put ground coffee in the filter.
Never forget that the coffee coming out of the appliance is very hot. Only move the
thermos flask very carefully to avoid splashing.
Always unplug the appliance after use !
Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
INITIAL OPERATION
•
For a perfect taste, carry out 2 or 3 boil-processes with fresh water (without coffee). These
boil-processes are absolutely necessary.
•
Once all the water has passed through, switch the appliance off and let it cool down
during 5 minutes. Then repeat the process with fresh water.
PREPARATION OF COFFEE
•
Open the lid of the water tank and pour the desired volume of water in it. Make sure not
to overfill by filling maximum 8 cups of water. The number of cups can be read from the
water level indicator (7).
•
Use the permanent filter or insert a paper filter (size 4) in the filter holder and add the
desired quantity of ground coffee (1 teaspoon per cup, approximately 6g). Pay attention:
fold the bottom and the side edges of the paper filter in such a way that it fits perfectly in
the filter holder.
•
Do never forget to close the lid of the water tank (4) before switching on your coffee
maker. !! Attention please close the lid exactly !!
•
Put the thermos flask (1) with closed lid on the supporting plate.
•
To switch on the machine, put the switch in position "I" and its pilot light will come on,
indicating that the appliance is working.
•
When the brewing process is over, remove the thermos flask from the supporting plate and
pour the desired amount of coffee, keeping the lever of the trickle-through lid pressed
down.
•
When you remove the thermos flask from the appliance, a non-drip valve will
automatically operate to stop any drops of coffee dripping onto the hotplate.
Replacement of the thermos flask automatically opens the non-drip valve and allows
remaining coffee to filter through into the thermos flask.
•
Wait until the brewing process is finished and the filter has run empty. Switch off the
appliance by putting the ON/OFF switch in position "0" and unplug it.
•
The thermos flask allows you to keep the coffee warm for quite some time.
•
Practical hints:
•
When the water tank is empty, wait a few additional minutes, as some water might
still drip out of the filter.
•
To keep the coffee warm, remove the flask from the appliance, as then the cap will
close itself hermetically.
•
Press the lever of the lid to pour coffee.
DECALCIFICATION AND CLEANING
•
When you notice that the coffee making process is longer than it should be, it is probably
time to decalcify the appliance. Do not wait until the situation gets worse. The
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
9
Back cover page (last page)
Assembly page 9/17
SC KA 520 - 091019
Werbung
Inhaltsverzeichnis
