Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fax +32 2 359 95 50
Never forget that the coffee coming out of the appliance is very hot. Only move the jug
very carefully to avoid splashing.
(*)
Competent qualified electrician: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
INITIAL OPERATION
•
When you use your appliance for the first time, pour fresh water into the water tank
(without coffee) and switch on the appliance.
•
Once all the water has passed through, switch the appliance off and let it cool down.
When it is cold enough repeat the process with fresh water. Repeat this process 3 times.
PREPARATION OF COFFEE
•
Open the lid of the water tank and the filter holder.
•
Pour the desired amount of water into the water tank. Both the glass jug and the scale on
the water tank show the amount for normal cups (1 cup = 125 ml) and small cups. Make
sure not to overfill by filling maximum 12 (15) cups of water.
•
Open the lid of the filter holder.
•
Use the permanent filter (included) or insert a paper filter (size 4) in the filter holder and
add the desired quantity of ground coffee (approximately 6g per cup, or a teaspoonful).
•
Never forget to close the lid before switching on your coffee maker.
•
Put the jug with closed lid on the hotplate.
•
Switch on the coffee maker by putting the switch in position "1". The pilot light will be
illuminated, indicating that your appliance is in use. Thanks to the keep warm function,
your coffee is warmed up as long as the appliance is switched on and the jug is situated
on the hotplate.
•
When the brewing process is over, remove the jug from the hotplate (the drip stop will
prevent dripping); pour the desired amount of coffee and put the jug with the remaining
coffee back on the hotplate.
•
However, we advise you not to let the appliance switched on more than 2 hours and
make sure that you never let an empty jug on the hotplate. The hotplate will only stop
heating up when the switch is in OFF position (i.e. position "0").
DESCALING AND CLEANING
•
We advise you to descale the coffee maker to prolong its life span. For descaling only use
products especially made for descaling of coffee makers and follow their instruction
manual. Then rinse the appliance twice with fresh water, without coffee powder.
Guarantee claims will not be accepted for appliances that have not been descaled.
•
Never use a dishwasher to clean the jug. Just clean it in soapsuds.
•
To clean the plastic parts of the appliance, use a damp, non abrasive cloth.
PRACTICAL HINTS
When you notice that the coffee making process is longer than it should be, it is probably time
to decalcify the appliance. Do not wait until the situation gets worse. The descaling frequency
depends on the amount of lime in water and therefore can be different from family to family.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Back cover page (last page)
Assembly page 9/9
Werbung
Inhaltsverzeichnis
