Stiga 155 B TITAN DOD Gebrauchsanweisung Seite 27

Cleaning position:
The deck is locked upwards at an angle. Used
when cleaning.
Service position:
The deck is locked straight upwards. Used during
inspections and repair.
3 ASSEMBLY
3.1 Mechanical connection
Also refer to the machine's instructions for use.
1. Lower the implement lift and slowly drive the
machine straight towards the cutting deck. Note
the alignment through the viewing grille in the
machine's floor.
2. Raise the implement lift to the transport posi-
tion when the pins in the implement lift corre-
spond with the holes in the cutting deck.
3. Lower the implement lift so that the cutting
deck touches the ground without the pins leav-
ing the holes.
4. Raise the implement lift so that the cutting deck
is just off the ground.
5. See fig. 1. Install the locking pins. The left lock-
ing pin is described below. The right locking pin
is installed in the same way, but mirror imaged.
• Insert the locking pin from the outside.
• Press the locking pin down over the lifting
beam.
3.2 Connecting the hydraulic hoses
This section only applies to decks which have the
hydraulic functions described.
Check the machine's hydraulic system
is not pressurised before connecting the
hydraulic hoses. Risk of extremely dan-
gerous oil spray while under high pres-
sure.
Check that all connectors are clean be-
fore connecting. Contaminants in the
hydraulic oil cause serious damage to
the hydraulic system.
Neutralise any overpressure in the machine's hy-
draulic system by moving all hydraulic controls
forward and backwards several times with the en-
gine stopped.
Clean all connectors that are to be connected.
Connect the hydraulic hoses according to the table
below.
ENGLISH
After connection, the deck is operated according to
the table.
Out- Control
put in in fig 2
fig. 2
PTO PTO1
L L1
Middle con-
trol
R R1
Right control
3.3 Installing the belt
This section only applies to decks with belt driven
cutting function.
The deck must be suspended on the machine be-
fore the belt is installed.
1. Set the deck in the transport position. Refer to
the machine's instructions for use.
2. Set the maximum cutting height. Refer to the
machine's instructions for use.
3. Place the belt around the machine's belt pulley
at the pivot point.
4. Tension the belt with the belt tensioner. See fig.
3.
3.4 Lowering speed
Set the deck's speed for lowering from the trans-
port position to the working position. Refer to the
machine's instructions for use.
3.5 Tyre pressure
Adjust the tyre pressures according to the ma-
chine's instructions for use.
4 DISMANTLING
4.1 Disconnecting the hydraulic
hoses
Check the machine's hydraulic system
is not pressurised before disconnecting
the hydraulic hoses. Risk of extremely
dangerous oil spray while under high
pressure.
Stop the engine. Neutralise any overpressure in the
machine's hydraulic system by moving all hydrau-
lic controls forward and backwards several times.
Disconnect the hydraulic hoses from the machine
output.
Install the plugs on the hydraulic outputs.
GB
Hoses Function
2 x 1/2" and 1 Operation of
x 1/4" the deck's
blades
2 x 1/4" Setting cut-
Marked with ting height
yellow ring
2 x 1/4" Opened and
closed
hatches
27