Stiga 155 B TITAN DOD Gebrauchsanweisung Seite 26

GB
1 GENERAL
This symbol indicates CAUTION. Seri-
ous personal injury and/or damage to
property may result if the instructions
are not followed carefully.
You must read these instructions for use
and the machine's safety instructions
carefully.
1.1 Symbols
The following symbols appear on the machine.
They are there to remind you of the care and atten-
tion required in use.
This is what the symbols mean:
Caution!
Read the instruction manual and the safety
manual before using the machine.
Caution!
Do not insert your hands or feet under the
cover when the machine is in operation.
Caution!
Watch out for discarded objects. Keep by-
standers away.
Caution!
Before starting repair work, remove the
ignition key from the machine.
Caution!
Applies to the hydraulically driven deck.
Always disconnect the hydraulic hoses
from the PTO socket before setting the
deck in the cleaning position or service
position. Risk of extremely dangerous oil
spray.
1.2 References
1.2.1 Figures
The figures in these instructions for use are num-
bered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component E in figure 5 is written
"5:E".
1.2.2 Headings
The headings in these instructions for use are num-
bered in accordance with the following example:
26
ENGLISH
"2.3.2" is a subheading to "2.3" and is included un-
der this heading.
When referring to headings, only the number of the
heading is normally specified. E.g. "See 2.3.2".
2 DESCRIPTION
2.1 General
The cutting deck is intended for use on Stiga Titan
according to the table below.
Deck
135B T DOD
155B T DOD
135H T DOD
155H T DOD
2.2 Controls and functions
2.2.1 Cutting height adjustment
The cutting height can be adjusted between 35 and
105 mm.
The setting can be adjusted infinitely variably us-
ing a hydraulic control on the machine.
2.2.2 Rear ejector
The cutting deck has two rear hatches, one on each
side. The hatches can be closed and opened using
a hydraulic control on the machine.
Opened hatches: Rear ejector.
Closed hatches: Multiclip.
2.2.3 Catch.
In the raised position the deck can be locked in the
cleaning and service position. Locking occurs via
catch.
2.2.4 Incline
The angle of the deck can be adjusted to achieve
different cutting characteristics. See "5.2".
2.2.5 Mounting in implement lifter
The deck is mounted in the implement lifter's lift-
ing beam via two holes at the rear. The suspension
is secured by a locking pin in each lifting member.
2.2.6 Positions
Definitions of the deck's different positions are de-
scribed below:
Floating position:
The deck rests under its own weight against the
ground and follows the contours of the ground dur-
ing operation.
Transporting position:
The deck is raised and does not touch the ground.
Used for transportation to and from the work place.
Machine
20 B 26 B 26 H 26 HS
X X
X
X X
X X