Mounting The New Battery Module; Maintenance On A Ups Equipped With The Hotswap Mbp Module; Training Centre - Eaton Powerware 5130 Installations- Und Bedienungsanleitung

Mounting the new battery module

Carry out the above instructions in reverse order.
◗ To ensure safety and high performance, use only batteries supplied by EATON Powerware
◗ Take care to firmly press together the two parts of the connector during remounting.

5.3 Maintenance on a UPS equipped with the HotSwap MBP module

HotSwap MBP

5.4 Training centre

For further information, please visit our website: www.powerware.com
7
49 50 51 52
The HotSwap MBP module makes it
8
possible to service or even replace the UPS
without affecting the connected loads
(HotSwap function).
Maintenance
1 - Set switch (53) to Bypass position. The red
LED on the HotSwap MBP module goes ON,
indicating that the load is supplied directly
with AC input source power.
9 10
2 - Stop the UPS by pressing the ON/OFF
button (24) on the UPS control panel. LED
44 (51) "UPS ON - OK to switch" goes OFF, the
UPS can now be disconnected and replaced.
Return to normal operation
1 - Check that the UPS is correctly connected
to the HotSwap MBP module.
2 - Start the UPS by pressing the ON/OFF
button (24) on the UPS control panel. LED
(51) "UPS ON - OK to switch" on the
HotSwap MBP module goes ON (otherwise,
53 54 55 56
there is a connection error between the
HotSwap MBP module and the UPS).
3 - Set switch (53) to Normal position. The red
LED on the HotSwap MBP module goes
31
OFF.
5. Maintenance
®
.
- Page 19
MAU-00069 AA