Glossary - Eaton Powerware 5130 Installations- Und Bedienungsanleitung

6.2 Glossary

Backup time
Battery test
Booster mode
Bypass AC input
Cold start
Deep discharge
Fader mode
FlexPDU
HotSwap MBP
Load
Low-battery warning
Normal AC input
Percent load
Personalisation
Programmable
outlets
UPS
UPS ON/OFF
controlled by
software
Time during which the load can be supplied by the UPS operating on battery power.
Internal UPS test to check battery status.
Automatic UPS mode that steps up the AC voltage if it is too low, to a level above the
personalised set-point, without discharging the battery.
Bypass line from the AC-power source, controlled by the UPS, used to directly supply the load if
an overload or a malfunction occurs on the UPS.
The devices connected to the UPS can be started even if AC input power is not available. The
UPS operates on battery power alone.
Battery discharge beyond the permissible limit, resulting in irreversible damage to the battery.
Automatic UPS mode that steps down the AC voltage if it is too high, to a level below the
personalised set-point, without discharging the battery.
Module with UPS outlets for installation in a bay. There are different modules with different types
of outlets.
UPS manual-bypass module for maintenance. There are different modules with different types of
outlets.
Devices or equipment connected to the UPS output.
This is a battery-voltage level indicating that battery power is low and that the user must take
action in light of the imminent break in the supply of power to the load.
The AC-power line supplying the UPS under normal conditions.
Ratio of the power effectively drawn by the load to the maximum output of the UPS.
It is possible to modify certain UPS parameters set in the factory. Certain UPS functions can also
be modified by the UPS Configuration Tool software to better suit user needs.
Controllable outlets for automatic load shedding, remote shutdown and sequential restart
(personalised using UPS Configuration Tool software.
Uninterruptible Power System.
This function enables or disables initiation of UPS ON/OFF control sequences by computer
power-management software.
6. Appendices
- Page 21
MAU-00069 AA