Turning On/Off The Leds - Spectra Precision HR500 Bedienungsanleitung

Turning On/Off the LEDs

The LEDs show the position of the receiver relative to the laser beam. The red
LED flashes when the receiver is within 13 mm (
continuously when the receiver is between 13 and 25 mm (
above or below the laser beam. The green LED flashes when the receiver is on grade.
On the HR500, the LEDs can also be used for lost beam indication. If the LEDs are
turned on, the high or low red LED flashes for 20 seconds to show the direction to
move the receiver to reacquire the beam. For additional lost beam indication, a bank of
up or down arrows in the LCD flash for 20 seconds to show the direction to move the
receiver to reacquire the beam.
Turning off the LEDs extends battery life.
The factory defaults setting for the LEDs is on.
1. Press the grade-sensitivity and power/
audio buttons repeatedly to turn the
LEDs on or off.
www.kreitel-vermessungsgeraete.de
6
1
/ in.) of being on grade and lights
2
1
/ in. and 1 in.) of being
2