Attaching the Receiver to the...
General-Purpose Clamp
The general-purpose clamp attaches to the receiver so the receiver can be used with a
grade rod or wooden pole.
1. Turn the battery-housing knob
counterclockwise to loosen the
battery-housing door.
2. Slide the receiver's groove onto the
clamp's tongue until it stops at the
edge-stop edge.
3. Turn the battery-housing knob
www.kreitel-vermessungsgeraete.de
clockwise to hold the receiver securely
in place.
4. To attach the clamp to a rod, turn the
jaws screw counterclockwise to open
the clamp's jaws.
5. Slide the clamp onto the rod.
6. Turn the jaws screw clockwise to
tighten the clamp to the rod.
Note: The level vial on the clamp can
be viewed from above or below to
verify that the rod is plumb.
9