Enabling Wifi Signal For Optional App - Dometic Waeco CoolFreeze CFX95DZ2 Bedienungsanleitung

CFX95DZ2
7.8

Enabling WiFi signal for optional app

The cooler can be controlled via WiFi using an app that you can install on a
compatible device. The app has control, display and alarm functions.
You find further information on the Dometic website for your country (see
back page). Note that the app may not be available in your country.
The WLAN name of the compressor cooler is "CFX95DZ2_xxxxxxxx". The
preset password is "00000000". You can change the WLAN name and
password individually.
Switching the WiFi signal on or off
➤ Press the "SET" button (fig. 3 4, page 2) five times.
➤ Use the "UP +" (fig. 3 10, page 2) and "DOWN –" (fig. 3 9, page 2)
buttons to switch the WiFi signal on or off.
✓ The desired setting appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
I
NOTE
The default setting for the WiFi transmitter is off. For first time
use and whenever power to the device is interrupted, switch
on the WiFi transmitter to use the app.
The WiFi transmitter uses a small amount of power. For opti-
mal energy performance switch the WiFi transmitter off if it is
not being used.
Resetting the WiFi to factory settings
In case you have personalized the WiFi settings of your cooling device using
the WiFi app and forgotten your password, you can reset to the factory
settings as follows:
➤ Press the "SET" button (fig. 3 4, page 2) five times.
➤ Hold the "UP +" (fig. 3 10, page 2) button for at least five seconds.
✓ In both displays "rES" will blink several times before returning to the
previous display.
✓ The WiFi settings have been reset to factory settings.
For additional information visit the Dometic website from which you down-
loaded the app.
EN
Operation
43