Nolan N44EVO Sicherheit Und Gebrauchsanleitung Seite 25

it with neutral liquid soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry in a
ventilated and dry place with the visor open after use.
Keep it away from heat sources and store it in a place away from direct light.
Do not use solvents or chemical products.
• USE CONFIGURATIONS (Fig. 33)
Using the helmet in its full configuration (chin guard fastened and visor pulled down)
definitely guarantees a higher level of protection if compared with the other possible
configurations.
• VENTILATION SYSTEM
The ventilation system of the N44 helmet consists of:
- lower air intake: it allows ventilation in the mouth and visor area. For maximum
effectiveness of the ventilation, move the outlet as described in figura 34.
Fig. 34A the air intake is completely open.
•
Fig. 34B the air intake is completely closed.
•
- central top air intake: it allows ventilation in the top area of the head thanks to
the innovative AIRBOOSTER TECHNOLOGY system that channels the air coming
from the top air intake by directing it in the top area of the rider's head without any
dispersion. For maximum effectiveness of the ventilation, move the slider until its limit
stop as described in figura 35.
Fig. 35A the air intake is completely open.
•
Fig. 35B the air intake is completely closed.
•
- side top air intakes: they allow the heat dissipation from the head. To open the
intakes, move the sliders until their limit stop as described in figura 34.
Fig. 36A the air intake is completely open.
•
Fig. 36B the air intake is completely closed.
•
- rear air extractors: they allow warm and stale air to flow out ensuring an optimum
comfort inside the helmet (Fig. 37).
• N-COM ® - NOLAN COMMUNICATION SYSTEM PRE-SETTING
Your Nolan helmet is factory-preset to be equipped with the N-Com communication system.
During communication system installation (see the specific instructions contained in the
N-Com kit) it will be necessary to remove the foam material lower back rest from the
helmet as shown in Fig. 38.
WARNING!!!
- The foam material lower back rest should ONLY be removed if the helmet is used
with an installed N-Com ® compatible system.
25