Nolan N44EVO Sicherheit Und Gebrauchsanleitung Seite 17

1.2 Unfasten the left-hand side cover from the visor by pushing out from the inside the
three click-on fastening elements (Fig. 6). Repeat the same operation for the right-
hand side cover.
1.3 Remove the visor air intake by first unfastening the internal air diffuser (A) and then
extracting the intake external part (B) from the outlet provided in the visor (Fig. 7)
2. VISOR ACCESSORY ASSEMBLY
2.1 Fasten the left-hand side cover to the visor by pushing the 3 click-on fastening
elements into their respective seats (Fig. 6). Repeat the same operation for the right-
hand side cover.
2.2 Place the intake external part (B) in the outlet provided in the visor and fasten the air
intake (A) from the inside by applying pressure to the two hooking and centring pins
on the sides (Fig. 7).
2.3 Fit the visor on the helmet by following the specific instructions contained in this manual.
WARNING!!!
- Ensure that the side covers have been correctly assembled. Open and close the
visor making sure that the covers are retained in their respective positions.
Check that the air intake is securely fastened to the visor by opening and closing
the outer flap. If necessary, repeat the above-mentioned steps.
- Never use the helmet without having correctly assembled all the visor accessories.
- In case of malfunctioning or damages, please contact an authorised Nolan dealer.
CHIN GUARD
•
1. CHIN GUARD RELEASE
1.1 Open the visor completely.
1.2 Pull the right and left chin guard release levers downwards and at the same time
remove the chin guard from the helmet, by pulling it towards the outside (Fig. 8).
WARNING: Every time you wish to release the chin guard to use your helmet in the
JET version, insert the right and left CHIN GUARD COVERS into the slots on the right
and left side frames and push them completely to the inside of the helmet (Fig. 9).
2. CHIN GUARD FASTENING
2.1 Open the visor completely.
Before fastening the chin guard to the helmet, remove the CHIN GUARD COVERS by
performing the following operations:
2.2 Remove the right and left side protections, by pulling them towards the outside (Fig. 8).
2.3 Insert the right and left ends of the chin guard simultaneously into the slots found on
the right and left side frames of the helmet, and press them towards the inside of the
helmet until you hear the fastening click (Fig. 10).
2.4 Make sure the chin guard is correctly fastened at both ends by gently pulling it
towards the outside of the helmet.
WARNING!
- Never remove the semi-rigid inner padding of the chin guard.
17