Nolan N44EVO Sicherheit Und Gebrauchsanleitung Seite 19

mechanism, the VPS makes these operations much easier.
WARNING
- The VPS can be used only during the day and under the environmental conditions
described before.
- At night and/or in poor visibility conditions, the VPS MUST be deactivated.
- Always check that the VPS is properly positioned according to the different weather/
environmental conditions and/or to the above mentioned recommendations for use.
- We recommend using the VPS only and solely together with the approved standard
visor, which has a transmittance value greater than 80%.
- Since the VPS does not assure you the same protection as the one provided by the
visor, it has to be used only when the helmet visor is pulled down.
- Always make sure that the VPS is clean and that it is operating properly in order to
avoid scratches and/or anomalous wear on it every time it is activated.
- ALWAYS check the correct VPS operation and in case of malfunctioning do not use
the helmet and contact immediately a Nolan authorized dealer.
- Please refer to the proper section in the helmet user's manual for the VPS and visor
maintenance and cleaning operations.
- The VPS scratch-resistant and fog-resistant treatment highly reduces fogging.
Protracted periods of adverse weather and/or environmental conditions might cause
fogging and/or formation of condensation on the VPS, which entails a reduction of
visibility and/or sharpness of vision: in this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the scratch-resistant and fog-
resistant treated VPS quickly reduces sharpness of vision, thus causing scarce
visibility: in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatures or
heat sources. In this case, contaminations caused by contact with other materials
might occur. These contaminations will cause marks and stains to develop. In these
cases (e.g. when the helmet is kept in the top case on hot days), it is recommended
to make sure the visor is not touching other materials.
1. VPS DISASSEMBLY
The VPS has been designed to ensure an easy, quick and tool-free disassembly.
To remove the VPS system from the helmet, open the helmet visor and fully lower the VPS
by pushing the side slider forward until its limit stop. (Fig. 11).
Hold the SX side part of the VPS and pull the VPS to front of the helmet (Fig. 13) in order
to release it from the side frame inside of the shell.
Repeat the same operation on the DX side of the helmet .
2. VPS ASSEMBLY
To assemble the VPS system, open the helmet visor and make sure the side slider is in
forward position up to its limit stop. (Fig. 11).
Insert the VPS SX end into the left side frame inside the shell until you hear a click
providing the fastening of the VPS (Fig. 13).
Repeat the same operation on the DX side.
19