Hitachi WF 4DY Bedienungsanleitung Seite 8

English
The tightening depth is adjusted by rotating the knob
and setting the stopper to the numerals (screw length)
indicated on the slider case.
Select a top adjuster to match screw length to be used
and attach it to the top edge. (Refer to Fig. 9)
Store the top adjuster in the storage room on the side
face of the slider case when it is not used.
The top adjuster is stored easily when the button
shown in Fig. 8 is pressed.
Top adjuster storage (rear side)
(1) In case that you use a screw which has a length
of 25-32 mm (L), please use the top adjuster No.
1 (small).
Top adjuster
Stopper Knob
No. 1 (small)
(2) In case that you use a screw which has a length
of 35-41 mm (L), please use the top adjuster No.
2 (large).
Top adjuster
Stopper Knob
No. 2 (large)
[Fine adjustment of tightening depth]
The tightening depth adjustments (1) to (2) men-
tioned above are just preliminary.
Perform fine adjustment after trial driving.
Rotate the knob in
head is too high.
Rotate the knob in
head is too low.
(Refer to Fig. 11)
7
Button
Fig. 8
Raise
Match the
stopper to
Lower
the screw
length
(25–32).
Fig. 9
Match the
stopper to the
screw length
(35–41).
Fig. 10
direction when the screw
direction when the screw
Correct Too high
(Flush)
COLLATED SCREW STRIPS INSTALLATION
AND REMOVAL
1. Installation
(1) Insert the tape tip of collated screw strips into the
belt guide groove (A section).
(2) Next, insert the tape tip into the slider groove (B
section) and feed to push in the \ direction.
(Fig. 12, Fig. 13 and Fig. 15)
(3) Set the collated tape so that the first screw is lined
up with the slider screw mark. (Fig. 14 and Fig. 15).
Slider
B section
A section
Belt guide
Collated screw
strips
(View from under)
Fig. 12
Set one screw
forward.
(View from front)
Too low
Fig. 11
Fig. 13
Slider
Screw
in position
Fig. 14