Cleaning And Lubrication - NovoPress EFP1 Bedienungsanleitung

5.12 Position intermediate jaw against press collar as follows:
Push intermediate jaw claws (21) as far as possible into grooves
(24) in press collar.
Close intermediate jaw.
Note
Device type 2:
Make sure that intermediate jaw claws (21) enclasp pins (22).
Failure to do so will result in breakage of intermediate jaw and
press collar.
Device type 3 (nominal size 76.1; 88.9 and 108 see device manual
ECO3/ECO301):
Intermediate jaw claws (21) must enclasp press collar pins (22).
Pressing will not be possible if intermediate jaw is not correctly
positioned.
5.13 Pressing
5.14 Open the intermediate jaw and detach from the press collar.
5.15 Open press collar and remove.
6. RE-PRESSING
Re-pressing is always necessary if pressing has not been fully
completed. There are a few peculiarities that must be observed for
re-pressing, in contrast to pressing.
Ensure that the claws of the intermediate jaw enclasp the press
collar pins during the re-pressing process. During the re-pressing,
the tool can be started, even though the claws are not enclasping
the pins properly. The tool is able to travel a large idle stroke as a
result of the respective pre-pressing of the fitting.
Because the tool is not correctly secured and a change in position
occurs during this phase, the claws my no longer enclasp the collar
pins properly.
Note!
The claws of the intermediate jaw may break as a result and the
press-loop pins may become damaged.
Injury hazard!!!!
13
7.

CLEANING AND LUBRICATION

Press jaw/interchangeable jaw/intermediate jaw/segments:
7.1 Regularly or when soiled:
• Clean segments all over using a solvent.
• Clean receiving contour (D) of segments using a solvent (e.g.
methylated spirit).
• Remove deposits from pressing contour (K).
• Clean pressing contour (K) of press jaw using a solvent.
• Lubricate pins in press jaw/interchangeable jaw/intermediate
jaw with machine oil.
• Coat press jaw, intermediate jaw, interchangeable jaw,
segments all over with a rust-inhibiting and anti-corrosion spray.
• Device type 3 only:
Clean contacts (16) in press jaw.
Clean jaw closing sensor (17).
Press collars:
7.2 Regularly and when soiled:
Press collars should be cleaned with compressed air.
Clean pressing contour (K) of press collars with a solvent (e.g.
methylated spirit).
Coat pressing contour (K) all over with lubricant.
Apply rust and corrosion-inhibiting spray all over press collar.
Recommended anti-corrosion product:
- WD-40® or equivalent
Recommended lubricants:
- OKS 400 MoS -multipurpose high-performance grease
2
(OKS Spezialschmierstoffe GmbH, Munich)
Device type 3 only:
Clean contacts (30).
After every 200 pressings:
Spray press collar joints (G) with graphite oil.
14