NovoPress EFP1 Bedienungsanleitung Seite 7

GB
ENGLISH
1. Intended use
The press jaws, intermediate jaws, interchangeable jaws and press
collars are exclusively intended for the use in press tools
manufactured by Novopress or approved by Novopress in
agreement with the system supplier. For further details, please
contact the system supplier.
The tool, press jaws and press collars serve exclusively for the
purpose of press-fitting pipes and fittings for which the relevant
press jaws and press collars are intended.
Any other or additional use is regarded as non-intended.
Novopress is not liable for any resulting consequences or damage.
Neither is it liable for press tools of other manufacturers nor for any
damage caused by such.
Intended use also includes observance of the Operating Manual,
adherence to the inspection and maintenance conditions as well as
compliance with all the relevant safety regulations.
9
2. Classification of the press tools
Device type 1 Device type 2
AFP101 EFP1
EFP2
ECO1
ACO1
ECO201
ACO201
EFP201
AFP201
EFP201plus
3. Interchangeable jaw
Fitting segments to interchangeable jaw
Push segments into interchangeable jaw as shown until they
engage.
NOTE
•
Make sure that the segments you fit are all of the same nominal
size. The nominal size is shown on the segments.
•
Make sure that segments engage.
Failure to do so will result in damage to the interchangeable jaw.
Removing segments from interchangeable jaw
Force out segment while pressing button (10).
Device type 3
EFP3
AFP3
ECO3
ACO3
ECO301
10