Medtronic MiniLink REAL-Time MMT-7703 Gebrauchsanweisung Seite 9

Answer: Your charger battery is low. Make sure the MiniLink is not
connected to the charger and replace the charger battery with a new AAA or
LR-03 battery.
Question: Why do I see a mix of quick and long flashing red lights on the
charger?
about about about 2 secs about about
1 sec 1 sec 1 sec 1 sec
Answer: Your charger AND MiniLink batteries are very low. Replace the
charger's AAA or LR-03 battery. If you now get the pattern for very low
MiniLink battery, leave the MiniLink on the charger for 8 hours to recharge.
If the red light is still flashing after 8 hours, call the HelpLine or your local
representative. It may be time to replace your MiniLink.
Question: I had my MiniLink on the charger for a day. Will this damage my
MiniLink?
Answer: It will not damage the MiniLink. You cannot overcharge it.
Question: What should I do if the MiniLink green light did not flash after
removing it from the charger?
Answer: Reconnect the MiniLink to the charger for at least one minute,
remove it and watch the MiniLink green light flash and then turn off.
Question: What should I do if the MiniLink green light does not flash when
connected to the sensor?
Answer: Is the sensor inserted in the body? If it is not inserted, the MiniLink
will not flash green or send signals to a monitoring device.
If the sensor is inserted in the body, you need to disconnect the MiniLink
from the sensor, wait for several seconds and then reconnect. If the green
light still does not flash, charge the MiniLink.
Question: Why didn't I see the MiniLink green light flash after connecting it
to the tester?
- 8 -