Medtronic MiniLink REAL-Time MMT-7703 Gebrauchsanweisung Seite 7

3 Hold the MiniLink as shown to line up the
two notches on both sides with the flexible
side arms of the sensor. The MiniLink flat
side with the label should face the skin.
4 Slide the MiniLink onto the sensor and push
it in firmly until the flexible side arms of the
sensor "click" into the notches on both sides
of the MiniLink. In the next 20 seconds the
MiniLink will flash green for about 10 seconds with a proper connection.
5 If the MiniLink light does not flash, disconnect it from the sensor, wait for
several seconds and then reconnect. If the MiniLink light still does not
flash, charge the MiniLink.
6 After the MiniLink light flashes green, use your monitor to start
communicating with the sensor and to start the sensor initialization (see
your monitor user guide for instructions).
7 After the MiniLink successfully sends signals to the monitor, you may
choose to put an occlusive dressing over the MiniLink and the sensor.
Bathing and swimming
After the MiniLink and sensor are connected, they form a water-tight seal to a
depth of 8 feet (2.4 meters) for up to 30 minutes. You can shower and swim
without removing them. No occlusive dressing is needed.
Disconnecting from sensor
1 Hold the MiniLink as shown, and pinch the
flexible side arms of the sensor between your
thumb and forefinger.
2 Gently pull the MiniLink away from the sensor
assembly.
MiniLink tester
The blue tester is used to test the MiniLink
and to make sure it is working.
Connecting the tester
1 Hold the MiniLink and the tester as
shown. Line up the flat side of the tester
- 6 -
sensor